 |
 |
|
Trade Notice No.2/2010 Dated Shillong the 22.02.2010
Subject: Irregular availment of Cenvat credit on certain activities not amounting to manufacture-reg.
The Trade, Industry and all concerned are informed that though certain activities including connectorising, testing, repacking and relabeling of feeder cables, cutting of HR/CR coils into sheets or slitting into strips do not amount to manufacture, such processors are taking Cenvat credit and justifying their Cenvat availment on ground that they are paying duty on final products. 2. The matter has been examined. As per the provisions of Rule 3 of the CENVAT Credit Rules, 2004, read with Rule 6, credit of duty paid on the inputs is allowed only if these inputs are used in the manufacture of a final product. The Board vide circular dated 26.09.07 issued from F.No.93/1/2005-CX3, had clarified that if the process does not amount to manufacture, duty is not required to be paid and hence no Cenvat credit of duty paid on inputs is admissible. Attention is also invited to the provisions of Section 5B of the Central Excise Act, 1944, where an assessee, who has paid excise duty on a product under the belief that the same is excisable, but subsequently the process of making the said product, is held by the Court as not amounting to manufacture, in such cases, the Central Government may issue an order for non-reversal of such credit in past cases. 3. In view of above, following instructions are issued:- If the assessee has already paid duty, and in a situation where there is no manufacture as held by the Courts subsequently, and facts of the case are covered by the provisions of Section 5B of the Central Excise Act, 1944, the assessee is at liberty to approach the Central Govt. for issue of appropriate notification for regularization of the Cenvat credit availed. 4. Hindi version will follow.
Authority: Circular No.911/01/2010-CX Dated New Delhi the 14th January 2010 ( S.R. Baruah Under F.No.267/116/2009-CX-8 Commissioner Of the CBEC, New Delhi |